GG8620 Operation Guide

1.Check that there is no large accumulation of steel needles or sewage on the workbench of the magnetic polishing machine.

2.Turn on the main power switch of the magnetic polishing machine, the equipment is powered on, and the fan on the side of the equipment starts to run.

3.Place the round polishing bucket in the center of the polishing platform

4.Add clean tap water to the polishing tank at a height of 6-8cm.Or take the cylinder in the center of the polishing tank as a reference, the water level is 2/3 of the height of the cylinder.

5.Add a clean magnetic needle of about 1.5-2kg to the polishing tank.

6.Add 300ml of brightener to the polishing tank (the higher the concentration, the higher the brightness of the product and the stronger the oxidation resistance

7.Press the power switch of the machine and the machine starts to work.

8.At this time, the total time relay starts timing, waits for the equipment to run for about 30s, and puts the product into the polishing tank for polishing.

9.Wait for the product to be polished, press the switch button again, and the equipment will stop working. You can also set the total time. After the time arrives, the device will automatically stop working.

10.Take the product out of the polishing tank and rinse with water.

11.Blow dry the water stains on the surface of the metal product and dry it。